Sea-Doo Drain Plug Loosening Wrench Tool
This 3D-printed tool makes loosening drain plugs and flush ports on your Sea-Doo watercraft or Switch effortless, even with wet fingers. Designed from durable PETG plastic, it features a directional arrow for easy use, center crosshairs for alignment, and a key ring hole for portability. Bright yellow for visibility, it even floats—unless weighed down. Compatible with Sea-Doo models using “S-shaped” drain plugs.
Description
This 3D-printed tool helps you loosen the drain plugs and flush ports on your Sea-Doo watercraft or Switch. The drain plugs can be difficult to loosen after a ride, especially with wet fingers and the limited grip area. This tool helps the process, allowing you to loosen, and then you remove the drain plug to release any water in the hull—a step often required by local laws to prevent the spread of organic matter between boat launches.
Key Features
– Made of PETG plastic.
– Directional arrow reminding you which way to loosen.
– Center crosshairs help align the tool with the drain plug.
– Key ring hole for easy storage and portability.
– Bright Yellow Color: Easy to spot.
– Floats on water (note: it won’t float if heavy items are attached to the key ring hole).
Compatibility
This tool works with Sea-Doo models featuring the “S-shaped” drain plug and flush ports, including but not limited to:
– 2009 and up: GTX Limited iS, RXT iS
– 2010 and up: All GTX, RXT, RXT-X
– 2011 and up: All GTI, GTS
– 2012 and up: RXP-X
– All Sea-Doo Switch models
Care & Instructions
– Make sure to loosen the drain plug SLOWLY so you don’t remove the whole drain plug housing, which is a pain to put back on. This is more of an issue on some models made between 2009-2020 (the models without the two screws next to the drain plug).
– Made of PETG plastic. Avoid storing in environments hotter than 150°F (65°C) to prevent damage.